Engineering Jobs   »   Electrical Engineering quizs   »   UPPCL 2021, UPPCL-JE ELECTRICAL QUIZ,

UPPCL-JE’21 EE: Daily Practices Quiz 08-Dec-2021


Uttar Pradesh Power Corporation Limited has rolled out the official notification for the recruitment of Assistant Engineers and Junior Engineers for a total of 286 UPPCL Vacancy 2021. The Online submission of the application form for UPPCL Recruitment 2021 starts on 12th November 2021 and the last date to apply for the same is 2nd December 2021.

UPPCL-JE’21 EE: Daily Practices Quiz

UPPCL-JE’21 EE: Daily Practices Quiz 08-Dec-2021

Each question carries 1 mark.
Negative marking: 1/4 mark
Total Questions: 06
Time: 06 min.

Q1. The capacity of a battery is measured in
(a) Watts
(b) Watt-hours
(c) Amperes
(d) Ampere-hours

Q2. DC shunt motors are commonly used in-
(a) Cranes
(b) Lathe machines
(c) Electric traction
(d) Elevators

Q3. In an NPN transistor, P region is called-
(a) Emitter
(b) Base
(c) Collector
(d) Source

Q4. What is the material used inside the breather to prevent moisture entering the transformer?
(a) Silica gel
(b) Sodium silicate
(c) Sodium chloride
(d) Copper sulphate

Q5. Wien’s bridge is used to measure……….
(a) Energy
(b) Power
(c) Frequency
(d) Phase angle

Q6. Load factor of a power station is generally
(a) Less than unity
(b) Equal to unity
(c) More than unity
(d) Equal to zero


S1. Ans.(d)
Sol. “Battery capacity” is a measure (typically in Amp-hr) of the charge stored by the battery.

S2. Ans.(b)
Sol. DC Shunt Motor Applications:
These motors are used wherever stable speed is required.
This kind of DC motor can be used in Centrifugal Pumps, Lifts, Weaving Machine, Lathe Machines, Blowers, Fans, Conveyors, Spinning machines, etc.

S3. Ans.(b)
Sol. In an NPN transistor, P region is called base.

S4. Ans.(a)
Sol. Silica gel Breather is cylindrical type container which is fitted to the conservator tank through a pipe line which is totally filled with silica gel crystals used for absorbing any moisture present in the air during breathing action of transformer due to expansion and contraction of transformer oil in the transformer.

S5. Ans.(c)
Sol. Wien’s bridge is used to measure frequency.

S6. Ans.(a)
Sol. load factor=(average load)/(maximum demand )
Load factor is always less than 1.


Sharing is caring!

Leave a comment

Your email address will not be published. Required fields are marked *