Engineering Jobs   »   Mechincal Engineering quizs   »   NHPC JE Recruitment 2021, NHPC JE...

NHPC JE’21 ME: Daily Practices Quiz. 19-Oct-2021

Quiz: Mechanical Engineering
Topic: Miscellaneous

Each question carries 1 mark
Negative marking: 1/4 mark
Time: 6 Minutes

Q1. Large size bolt heads are made by
(a) hammering
(b) casting
(c) swaging
(d) upset-forging

Q2. The temperature of wrought iron in forging is………………
(a) 12750C
(b) 5000C
(c) 9500C
(d) 1750C

Q3. Which process is used to improve fatigue resistance of the metal by setting up compressive stresses in its surfaces?
(a) Cold peening
(b) Cold heading
(c) Hot piercing
(d) Extrusion

Q4. Anvil is made of which of the following metal?
(a) Mild steel
(b) Cast steel
(c) Copper
(d) Brass

Q5. The operation of producing cup shaped parts from flat sheet metal blanks by bending and plastic flow of metal is know
(a) Coining
(b) Planishing
(c) Squeezing
(d) Drawing

Q6. Which of the following has maximum ductility?
(a) Copper
(b) Mild Steel
(c) Cast Iron
(d) 18-4-1 Steel


S1. Ans(d)
Sol. Large size head bolts are manufactured by the technique of UPSET FORGING.

S2. Ans(a)
Sol. Wrought iron is an alloy of iron which contain very less amount of carbon in it so it is always forged temperature below 13000C. So, option A is correct which is nearest to the 13000C.

S3. Ans(a)
Sol. Cold peeing technique is used to increase the fatigue strength by setting up compressive stresses on the surface of the component. It is also known as short peening.

S4. Ans(b)
Sol. Anvil is made of cast steel.

S5. Ans(d)

S6. Ans.(a)
Sol. Copper is more ductile material from the given option.

Sharing is caring!

Published by VINAYAK KUMAR

Graduated from BIT Sindri, Postgraduated from IIT BHU Varanasi

Leave a comment

Your email address will not be published. Required fields are marked *