Correct option is A
According to the given figure, The minimum number of line required is 9.
All Courses
Question
What is the minimum number of lines required to make the given image?
Similar Questions
- 1)
Which of the following vices consists of a handle and a small collet chuck at one end?
- 2)
According to BIS SP 46-2003, which of the following applications is correctly represented by a chain-thin line in engineering drawings?
- 3)
What is the unit of specifying slip gauges?
- 4)
___________ microstructure is typically obtained after normalising low-carbon steel.
- 5)
Which of the following is a key characteristic of a low-pressure blowpipe/torch in welding?
- 6)
Which of the following is NOT required for estimating materials in preventive maintenance?
- 7)
Which of the following parts of a file is the part fitted to the tang for holding the file?
- 8)
Which hardness test uses a diamond pyramid-shaped indenter?
- 9)
The unit for specific gravity is _____.
- 10)
When selecting a sheet size for an original drawing, what should be the primary consideration?
Access ‘RRB ALP Fitter’ Mock Tests with
- 60000+ Mocks and Previous Year Papers
- Unlimited Re-Attempts
- Personalised Report Card
- 500% Refund on Final Selection
- Largest Community
446k+ students have already unlocked exclusive benefits with Test Prime!
Access ‘RRB ALP Fitter’ Mock Tests with
- 60000+ Mocks and Previous Year Papers
- Unlimited Re-Attempts
- Personalised Report Card
- 500% Refund on Final Selection
- Largest Community
446k+ students have already unlocked exclusive benefits with Test Prime!
Similar Questions
- 1)
Which of the following vices consists of a handle and a small collet chuck at one end?
- 2)
According to BIS SP 46-2003, which of the following applications is correctly represented by a chain-thin line in engineering drawings?
- 3)
What is the unit of specifying slip gauges?
- 4)
___________ microstructure is typically obtained after normalising low-carbon steel.
- 5)
Which of the following is a key characteristic of a low-pressure blowpipe/torch in welding?
- 6)
Which of the following is NOT required for estimating materials in preventive maintenance?
- 7)
Which of the following parts of a file is the part fitted to the tang for holding the file?
- 8)
Which hardness test uses a diamond pyramid-shaped indenter?
- 9)
The unit for specific gravity is _____.
- 10)
When selecting a sheet size for an original drawing, what should be the primary consideration?
