When the size of the shaft or male part of a job is more than hole or female part, the difference between the two will be known as ____________.
Allowance is the intentional difference between mating parts (shaft and hole). When the shaft size is larger than the hole, it results in an interference fit, meaning parts must be forced together. In such cases, the allowance is called negative allowance because clearance is negative.
Positive allowance refers to clearance fits where the hole is larger than the shaft. Since the shaft is bigger in this case, the difference is negative.
According to BIS SP 46-2003, which of the following applications is correctly represented by a chain-thin line in engineering drawings?
If the current flowing through a conductor is 5 A and the resistance of the conductor is 10 ohms, what will be the voltage across the conductor, according to Ohm's Law?
What is single-riveted lap joint?
When two pulleys are more than 8 metres apart, then which of the following belt drives is used for power transmission?
Which of the following is NOT a failure mode of ball bearings?
Silicon carbide as a honing abrasive is best suited for which type of material?
Which hardness test uses a diamond pyramid-shaped indenter?
___________ microstructure is typically obtained after normalising low-carbon steel.
What does 'charging' of a lapping tool mean?
In a forward Vernier scale, the size of one Vernier scale division is:
