Correct option is A
Question
Find the current (in mA) flowing through a wire of resistance 25 kΩ when a potential difference of 12.5 V is applied across it.
Similar Questions
- 1)
Arrange the following steps in the correct order to draw an equilateral triangle with each side of 35 mm.
1. Join CA and CB.
2. Draw a line and mark AB 35 mm as the side of the triangle.
3. With radius AB and center A and B, draw arcs cutting at C.
4. ABC is the required triangle. - 2)
A circuit consists of three resistors; 15 ohms, 10 ohms, and 20 ohms. The 15-ohm resistor is in series with the parallel combination of the 10-ohm and 20-ohm resistors. If a 24 V battery is applied across the circuit, what is the total current flowing through the circuit?
- 3)
Which of the following is NOT required for estimating materials in preventive maintenance?
- 4)
If the basic size of the diameter of a shaft is 75 mm and variation limit of +0.02 mm is
given, then its tolerance in mm is: - 5)
Identify the rough file grade from the figures given below.
- 6)
_________ type of preventive maintenance is performed based on actual machine condition rather than a fixed schedule.
- 7)
In thread cutting, 'BSW' stands for _________________.
- 8)
If the current flowing through a conductor is 5 A and the resistance of the conductor is 10 ohms, what will be the voltage across the conductor, according to Ohm's Law?
- 9)
When using a multimeter to measure current, which of the following is correct?
- 10)
The key difference between a marking gauge and a mortise gauge is:
Access ‘RRB ALP Fitter’ Mock Tests with
- 60000+ Mocks and Previous Year Papers
- Unlimited Re-Attempts
- Personalised Report Card
- 500% Refund on Final Selection
- Largest Community
564k+ students have already unlocked exclusive benefits with Test Prime!
Access ‘RRB ALP Fitter’ Mock Tests with
- 60000+ Mocks and Previous Year Papers
- Unlimited Re-Attempts
- Personalised Report Card
- 500% Refund on Final Selection
- Largest Community
564k+ students have already unlocked exclusive benefits with Test Prime!
Similar Questions
- 1)
Arrange the following steps in the correct order to draw an equilateral triangle with each side of 35 mm.
1. Join CA and CB.
2. Draw a line and mark AB 35 mm as the side of the triangle.
3. With radius AB and center A and B, draw arcs cutting at C.
4. ABC is the required triangle. - 2)
A circuit consists of three resistors; 15 ohms, 10 ohms, and 20 ohms. The 15-ohm resistor is in series with the parallel combination of the 10-ohm and 20-ohm resistors. If a 24 V battery is applied across the circuit, what is the total current flowing through the circuit?
- 3)
Which of the following is NOT required for estimating materials in preventive maintenance?
- 4)
If the basic size of the diameter of a shaft is 75 mm and variation limit of +0.02 mm is
given, then its tolerance in mm is: - 5)
Identify the rough file grade from the figures given below.
- 6)
_________ type of preventive maintenance is performed based on actual machine condition rather than a fixed schedule.
- 7)
In thread cutting, 'BSW' stands for _________________.
- 8)
If the current flowing through a conductor is 5 A and the resistance of the conductor is 10 ohms, what will be the voltage across the conductor, according to Ohm's Law?
- 9)
When using a multimeter to measure current, which of the following is correct?
- 10)
The key difference between a marking gauge and a mortise gauge is:
