Correct option is A
All Courses
Question
Adrum of mass ‘m’ kg was rolled down a ramp. At the bottom of the ramp its kinetic energy was 10 kJ and velocity was 20 m/s. With what velocity (in m/s) was it
pushed down the ramp if its initial kinetic energy was 625 J?
Similar Questions
- 1)
Which of the following vices consists of a handle and a small collet chuck at one end?
- 2)
According to BIS SP 46-2003, which of the following applications is correctly represented by a chain-thin line in engineering drawings?
- 3)
What is the unit of specifying slip gauges?
- 4)
___________ microstructure is typically obtained after normalising low-carbon steel.
- 5)
Which of the following is a key characteristic of a low-pressure blowpipe/torch in welding?
- 6)
Which of the following is NOT required for estimating materials in preventive maintenance?
- 7)
Which of the following parts of a file is the part fitted to the tang for holding the file?
- 8)
Which hardness test uses a diamond pyramid-shaped indenter?
- 9)
The unit for specific gravity is _____.
- 10)
When selecting a sheet size for an original drawing, what should be the primary consideration?
Access ‘RRB ALP Fitter’ Mock Tests with
- 60000+ Mocks and Previous Year Papers
- Unlimited Re-Attempts
- Personalised Report Card
- 500% Refund on Final Selection
- Largest Community
446k+ students have already unlocked exclusive benefits with Test Prime!
Access ‘RRB ALP Fitter’ Mock Tests with
- 60000+ Mocks and Previous Year Papers
- Unlimited Re-Attempts
- Personalised Report Card
- 500% Refund on Final Selection
- Largest Community
446k+ students have already unlocked exclusive benefits with Test Prime!
Similar Questions
- 1)
Which of the following vices consists of a handle and a small collet chuck at one end?
- 2)
According to BIS SP 46-2003, which of the following applications is correctly represented by a chain-thin line in engineering drawings?
- 3)
What is the unit of specifying slip gauges?
- 4)
___________ microstructure is typically obtained after normalising low-carbon steel.
- 5)
Which of the following is a key characteristic of a low-pressure blowpipe/torch in welding?
- 6)
Which of the following is NOT required for estimating materials in preventive maintenance?
- 7)
Which of the following parts of a file is the part fitted to the tang for holding the file?
- 8)
Which hardness test uses a diamond pyramid-shaped indenter?
- 9)
The unit for specific gravity is _____.
- 10)
When selecting a sheet size for an original drawing, what should be the primary consideration?
