Correct option is A
Horsepower is a unit of power that is commonly used to measure the power of engines and motors. In the SI system, 1 horsepower (hp) is equal to
746 watts (W).
All Courses
Question
One horse-power (hp) 1 hp = _________-W.
Similar Questions
- 1)
If the basic size of the diameter of a shaft is 75 mm and variation limit of +0.02 mm is
given, then its tolerance in mm is: - 2)
The process of ________ involves using a cutting tool called a tap to sever internal threads in a hole.
- 3)
When two pulleys are more than 8 metres apart, then which of the following belt drives is used for power transmission?
- 4)
The type of workpieces that can be successfully held in a 4-jaw chuck, and might be difficult to hold in a 3-jaw chuck, are:
- 5)
A/An ________ is provided to keep the micrometer fixed so that the reading can be done easily and without any difficulty.
- 6)
What is the difference between a bevel gauge and a bevel protractor?
- 7)
If the current flowing through a conductor is 5 A and the resistance of the conductor is 10 ohms, what will be the voltage across the conductor, according to Ohm's Law?
- 8)
What is the purpose of a split die in pipe threading?
- 9)
The schedule number of a pipe is an indicator of which property?
- 10)
Which of the following hand-operated drilling machines is used for drilling small diameter holes up to 6 mm?
Access ‘RRB ALP Fitter’ Mock Tests with
- 60000+ Mocks and Previous Year Papers
- Unlimited Re-Attempts
- Personalised Report Card
- 500% Refund on Final Selection
- Largest Community
446k+ students have already unlocked exclusive benefits with Test Prime!
Access ‘RRB ALP Fitter’ Mock Tests with
- 60000+ Mocks and Previous Year Papers
- Unlimited Re-Attempts
- Personalised Report Card
- 500% Refund on Final Selection
- Largest Community
446k+ students have already unlocked exclusive benefits with Test Prime!
Similar Questions
- 1)
If the basic size of the diameter of a shaft is 75 mm and variation limit of +0.02 mm is
given, then its tolerance in mm is: - 2)
The process of ________ involves using a cutting tool called a tap to sever internal threads in a hole.
- 3)
When two pulleys are more than 8 metres apart, then which of the following belt drives is used for power transmission?
- 4)
The type of workpieces that can be successfully held in a 4-jaw chuck, and might be difficult to hold in a 3-jaw chuck, are:
- 5)
A/An ________ is provided to keep the micrometer fixed so that the reading can be done easily and without any difficulty.
- 6)
What is the difference between a bevel gauge and a bevel protractor?
- 7)
If the current flowing through a conductor is 5 A and the resistance of the conductor is 10 ohms, what will be the voltage across the conductor, according to Ohm's Law?
- 8)
What is the purpose of a split die in pipe threading?
- 9)
The schedule number of a pipe is an indicator of which property?
- 10)
Which of the following hand-operated drilling machines is used for drilling small diameter holes up to 6 mm?
