Gaskets, seals and spacers are made using:
A hollow punch is used to cut circular holes in soft materials such as rubber, leather, gasket sheets, and thin plastic. Therefore, it is ideal for making gaskets, seals, and spacers, which require precise circular shapes.
Other punches serve different purposes: centre punch marks drilling points, pin punch removes pins, and prick punch is used for layout marking. None of these are suitable for cutting holes.
Arrange the following steps in the correct order to draw an equilateral triangle with each side of 35 mm.
1. Join CA and CB.
2. Draw a line and mark AB 35 mm as the side of the triangle.
3. With radius AB and center A and B, draw arcs cutting at C.
4. ABC is the required triangle.
If the current flowing through a conductor is 5 A and the resistance of the conductor is 10 ohms, what will be the voltage across the conductor, according to Ohm's Law?
Gaskets, seals and spacers are made using:
The key difference between a marking gauge and a mortise gauge is:
Compared to other types of transistors, what is the main advantage of using MOSFETs in electronic circuits?”
What is the purpose of an emergency evacuation plan?
According to BIS SP 46-2003, which of the following applications is correctly represented by a chain-thin line in engineering drawings?
What is the difference between a bevel gauge and a bevel protractor?
When two pulleys are more than 8 metres apart, then which of the following belt drives is used for power transmission?
Threading is an operation of cutting __________ on the external cylindrical surface of the job.
Arrange the following steps in the correct order to draw an equilateral triangle with each side of 35 mm.
1. Join CA and CB.
2. Draw a line and mark AB 35 mm as the side of the triangle.
3. With radius AB and center A and B, draw arcs cutting at C.
4. ABC is the required triangle.
If the current flowing through a conductor is 5 A and the resistance of the conductor is 10 ohms, what will be the voltage across the conductor, according to Ohm's Law?
Gaskets, seals and spacers are made using:
The key difference between a marking gauge and a mortise gauge is:
Compared to other types of transistors, what is the main advantage of using MOSFETs in electronic circuits?”
What is the purpose of an emergency evacuation plan?
According to BIS SP 46-2003, which of the following applications is correctly represented by a chain-thin line in engineering drawings?
What is the difference between a bevel gauge and a bevel protractor?
When two pulleys are more than 8 metres apart, then which of the following belt drives is used for power transmission?
Threading is an operation of cutting __________ on the external cylindrical surface of the job.
